Intermittent steering shake upon braking
#1
Lead Lap
Thread Starter
Intermittent steering shake upon braking
Although this topic has been discussed before, I was wondering if there might be some new insight to my recent issue. Upon initially purchasing my 2001 LS430 which had 98,000, I had a horrible steering shake upon braking and had the front rotors turned and brakes replaced even though there was 50% pad left. Everything was fine after the install. 5,000 miles and a year later I had a slight steering wheel shake upon breaking once and then it could not be duplicated. Again today, upon braking I experienced the steering shake and no matter how many times I tried to get the vibration back I couldn't. What's up with that? If the rotors are warped why don't they constantly cause the same steering wheel shake whenever I brake? I'm taking my car in tomorrow to get the rear pads changed and have asked to have the tech check the runout on the front rotors. All suspension parts have been thoroughly checked at Lexus and all is fine. Any feedback would be greatly appreciated.
#3
Lead Lap
Thread Starter
#4
Lexus Test Driver
Check two threads below about 'pads'. This will give some info about my experiences... Not saying it's definitely relateed to your case, but everything is possible i guess.
#5
Lead Lap
Thread Starter
I haven't heard that before about OEM pads. I'm not sure it would be related to my situation and again, why intermittent steering shake?
#7
Are you braking hard and they are heating up more so than on another occassion? Mine will vibrate once in a while usually when I am hard braking and they would seem to heat up more.
Trending Topics
#8
Lead Lap
Thread Starter
#10
Could be rotors (new rotors will warp if overheated by hard braking during the break-in period), rotors could have a contamination, pads not seated properly, wheel bearings, shocks, etc.
#11
has your Brake fluid been flushed and new put in? I bet you can get that Vibration to return if you brake steady down a hill - and without actually being in the car to get a better analysis on the issue, its a shot in the dark. I would personally think that it is your Turned/resurfaced rotors. they did not bed in properly over time with the new pads and the "transferred" or "exchanged" material from the pad to the rotor has more buildup on certain areas of one or both sides of the rotors - which only comes to surface due to heating of the Rotors under long, steady braking. take note this is only a best guess though -
but let us now what the Mechanic finds out. good luck!
but let us now what the Mechanic finds out. good luck!
#12
Lead Lap
Thread Starter
has your Brake fluid been flushed and new put in? I bet you can get that Vibration to return if you brake steady down a hill - and without actually being in the car to get a better analysis on the issue, its a shot in the dark. I would personally think that it is your Turned/resurfaced rotors. they did not bed in properly over time with the new pads and the "transferred" or "exchanged" material from the pad to the rotor has more buildup on certain areas of one or both sides of the rotors - which only comes to surface due to heating of the Rotors under long, steady braking. take note this is only a best guess though -
but let us now what the Mechanic finds out. good luck!
but let us now what the Mechanic finds out. good luck!
#14
Lead Lap
Thread Starter