2000 LS Foglight mod. (hid)
Trending Topics
#14
Ok, I messed around with the other projector today and have them finished 80%. I just need to mess around with aiming them.
here are some pics.
driver side projector in, other side just modded with 9005 bulb.
Passenger side in.
Here is the cutoffs with both installed, I have some tweaking to do.
low beams only, fogs off.
so far im very happy with the light output.
I still have to install the wiring harness and relays, as well as the wires for the Bi-xenon solinoid for the highs. So right now these are being run off the factory harness. I was too excited to see what they looked like.
here are some pics.
driver side projector in, other side just modded with 9005 bulb.
Passenger side in.
Here is the cutoffs with both installed, I have some tweaking to do.
low beams only, fogs off.
so far im very happy with the light output.
I still have to install the wiring harness and relays, as well as the wires for the Bi-xenon solinoid for the highs. So right now these are being run off the factory harness. I was too excited to see what they looked like.
Last edited by rick1987; 07-04-14 at 04:20 AM.
#15
Here is a little how to, or what i did. for those that are interested.
stock fog
heat gun.
Heat around the front of the fog, where the lens goes into the housing. GO EASY! slow and steady!
and dont forget about this screw.
gently pry the lens off, if it gets difficult use more heat.
Here is the glare thingy that gives us ****y light output. remove this.
Now these two screws
Now these two screws. then you need to loosen the adjustment screw on the back until the bowl comes free.
Here is the projector.
the shroud need to come off, it doesnt fit.
Thats better!
Now things are going to get scary for some of you. After this you are committed.
We need to modify this.
stock fog
heat gun.
Heat around the front of the fog, where the lens goes into the housing. GO EASY! slow and steady!
and dont forget about this screw.
gently pry the lens off, if it gets difficult use more heat.
Here is the glare thingy that gives us ****y light output. remove this.
Now these two screws
Now these two screws. then you need to loosen the adjustment screw on the back until the bowl comes free.
Here is the projector.
the shroud need to come off, it doesnt fit.
Thats better!
Now things are going to get scary for some of you. After this you are committed.
We need to modify this.