Upper Control Arm Ball Joints
#1
Driver
Thread Starter
iTrader: (1)
Join Date: Sep 2012
Location: CA
Posts: 131
Likes: 0
Received 0 Likes
on
0 Posts
Upper Control Arm Ball Joints
My front end has clunking for a while. I jacked up both front wheels and checked for play and found nothing. I removed both wheels and found both upper control arm ball joints and tie rod ends feel sloppy. Can this be the culprit?
I did some searching but it's not clear what the real problem is. I don't wanna bring the car to the stealer and pay for diagnose if I can avoid it.
I did some searching but it's not clear what the real problem is. I don't wanna bring the car to the stealer and pay for diagnose if I can avoid it.
#3
Try doing the wiggle test, jack the car off the ground, hold the wheel at 12 and 6 o clock. Push at 12 and pull from 6. If its bad you should be able to affect the movement. Also if you take off the wheel check for any tears on the rubber of the ball joint. If it's torn it's likely it's finished.
#4
Driver
Thread Starter
iTrader: (1)
Join Date: Sep 2012
Location: CA
Posts: 131
Likes: 0
Received 0 Likes
on
0 Posts
Try doing the wiggle test, jack the car off the ground, hold the wheel at 12 and 6 o clock. Push at 12 and pull from 6. If its bad you should be able to affect the movement. Also if you take off the wheel check for any tears on the rubber of the ball joint. If it's torn it's likely it's finished.
Thread
Thread Starter
Forum
Replies
Last Post
ahero4all
Suspension and Brakes
4
02-28-18 12:31 PM