Airbag Suspension not level
10-14-12, 07:16 PM
#1
Driver School Candidate
Thread Starter
Join Date: Oct 2012
Location: NSW
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Airbag Suspension not level
Hi. I have a 89 toyota celsior with air bag suspension, and on full drop the driverside sits a little higher up then the passenger. Ive been told the solenoids, but how do i check them or if it could be another issue like my aftermarket height controller (loose wiring?). Thanks.
Last edited by YAK00Z; 10-14-12 at 07:54 PM.
10-15-12, 10:58 AM
#2
well the aftermarket controller could be causing the problem but i tend to lean towards the air suspension on its way out. i'm assuming that this is the factory 23 year old suspension. at this age they typically display lots of problems in which most owners ditch them in favor of new aftermarket air suspension or coilovers. good luck!
10-15-12, 02:05 PM
#3
Driver School Candidate
Thread Starter
Join Date: Oct 2012
Location: NSW
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Well I've noticed at times the suspension won't drop cause the wires are a tad loose and I have to press against it to get it to work, I was thinking due to that issue a position sensor wire or something could be the issus
Thread
Thread Starter
Forum
Replies
Last Post
CircuitMS
Club Lexus Vendor Marketplace
37
11-20-12 11:36 AM
2tirefire
LS - 1st and 2nd Gen (1990-2000)
2
12-02-06 06:49 AM
billy boi
LS - 1st and 2nd Gen (1990-2000)
4
07-28-05 07:33 AM
