Possible header production..
#1
Guest
Posts: n/a
Possible header production..
I ran into a guy with a drag civic over at R&D dyno in Gardena (CA)today who had custom built headers. I asked him where he had them made and he said a guy out in Woodland hills or something.
I told him about the large interest in 1UZ-FE headers and if I got some contacts ready I would hand them over to him for a possible production start and group buy. If it did get far enough, would Manaray would be the next to take care of that?
Now I don't know how far this will go, but if I can push for it it might happen. He said he needed a test car for about 2 weeks. Healerhand - I mentioned I knew someone with a TT LS400 who might be interested in donating his car for a while to test out some headers. I didn't mention any names or anything, don't worry.
I'd like to get a number together and a confirmation that the headers on the LS and SC4's are the same. If so, I'll post this in the SC forum and start collecting a few numbers to get an estimate and stuff.
If anyone is interested please respond.
-Lee
I told him about the large interest in 1UZ-FE headers and if I got some contacts ready I would hand them over to him for a possible production start and group buy. If it did get far enough, would Manaray would be the next to take care of that?
Now I don't know how far this will go, but if I can push for it it might happen. He said he needed a test car for about 2 weeks. Healerhand - I mentioned I knew someone with a TT LS400 who might be interested in donating his car for a while to test out some headers. I didn't mention any names or anything, don't worry.
I'd like to get a number together and a confirmation that the headers on the LS and SC4's are the same. If so, I'll post this in the SC forum and start collecting a few numbers to get an estimate and stuff.
If anyone is interested please respond.
-Lee
Thread
Thread Starter
Forum
Replies
Last Post
bcsc400
Performance & Maintenance
11
08-22-10 09:21 AM