LS400 NRCAs
#1
Pole Position
Thread Starter
iTrader: (5)
Join Date: Aug 2009
Location: WA
Posts: 332
Likes: 0
Received 0 Likes
on
0 Posts
LS400 NRCAs
My buddy just made me some NCRAs so that I can adjust my front camber significantly more at my current height.
Pictures of them installed on his car.
Pictures of the NCRAs on his UCF10. This is minimum negative camber (-4 according to his math). I'll post some pictures of max as soon as I pic up my set.
The they are made out of 6061-T6 Aluminum and the hardware used is 12.9 grade. They also lower the car 1.25 inches in addition to adding almost another inch of coil-over travel.
Pictures of them installed on his car.
Pictures of the NCRAs on his UCF10. This is minimum negative camber (-4 according to his math). I'll post some pictures of max as soon as I pic up my set.
The they are made out of 6061-T6 Aluminum and the hardware used is 12.9 grade. They also lower the car 1.25 inches in addition to adding almost another inch of coil-over travel.
Last edited by S30ZG; 07-03-11 at 10:54 PM.
#5
i gotta wonder why this hasn't been done before. seems like it has to have been thought of before which makes me wonder why it's not on the market. can't think of anything at the moment.
Trending Topics
#8
Any one haw any info on the mock ups or drawings?! friend does milling he was asking me to see if ther are any pics or whatnot so he debt need to start from scratch? any help would b a big help!!!
#9
BahHumBug
iTrader: (10)
actually all you need are the center-center distances of the 2 holes for the lower ball joints, diameters of the bolts, and have him mill a steel insert sleeve.
its more of a production cost thing than a design issue. (for RCAs, NRCAs require more math/geometry to get the right camber change.)
its more of a production cost thing than a design issue. (for RCAs, NRCAs require more math/geometry to get the right camber change.)
Thread
Thread Starter
Forum
Replies
Last Post
sam430
GS - 4th Gen (2013-2020)
3
05-07-16 08:53 AM