Stripped trans pan-to-case bolt
#1
Instructor
Thread Starter
Stripped trans pan-to-case bolt
Today I pulled the pan again to install the magnets that were missing along with a new filter. I only use 1/4 drive stuff to install the bolts at just the right amount of torque. One of the bolts along the side stripped today. I don't think it is really leaking but I havn't driven it much yet. It may not leak but I still want to fix it.
Has anyone else ran into this before? Any ideas on a new larger size bolt and tap? Hoping it can be driven without leaking with the stripped bolt until I ever need to pull the pan again to fix it the right way.
Has anyone else ran into this before? Any ideas on a new larger size bolt and tap? Hoping it can be driven without leaking with the stripped bolt until I ever need to pull the pan again to fix it the right way.
#2
Pole Position
Join Date: Nov 2001
Location: Hamburg, Germany
Posts: 318
Likes: 0
Received 0 Likes
on
0 Posts
Hi,
one missing bolt will not really matter.
I would not do anything at the moment.
The next time you take the pan off you can just unscrew it, buy a new bolt and done.
Christian
one missing bolt will not really matter.
I would not do anything at the moment.
The next time you take the pan off you can just unscrew it, buy a new bolt and done.
Christian
#3
Instructor
Thread Starter
It will have to be tapped out to a larger size and have a larger bolt installed. I tend to agree with you though, it shouldn't leak right now but it may need attention later.
Thread
Thread Starter
Forum
Replies
Last Post
joshoowa
Suspension and Brakes
35
04-30-05 09:41 AM