Vac Line on Power steering pump air valve?
#1
Driver School Candidate
Thread Starter
Join Date: Dec 2008
Location: TN
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Vac Line on Power steering pump air valve?
-I need a litte help---I didn't mark the lines coming off the valve when I replaced my power steering pump---Can anyone tell me which line goes where on the valve---or does it mater--- One line goes into the plastic intake and the other is located on the front of the metal intake on top of the motor. My old valve completely let go and pumped all the fluid in to the motor--White smoke every where---Very interesting to see--NOT! Have everything ready to go back together but just need this little bit information---On one side of the valve is a flat bump and the other side is rounded--
THanks
THanks
Last edited by hp32si; 01-07-10 at 02:58 PM.
#3
Driver School Candidate
Thread Starter
Join Date: Dec 2008
Location: TN
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
vaughn37- thanks for the response-I thought there would be a pressure differential between the two areas---that is my concern-hooking up the high pressure vacuum to the lower pressure side and blowing out the valve----
Thread
Thread Starter
Forum
Replies
Last Post