Daniel N

Hi,

I'm thinking about getting some 19" x 8,5" or 9,5" WALD Duchatlet One-Piece rims and Tanabe lowering springs on my LS400 from 1993. Since 16"x7" is standart, will the 19"'s fit and how much wider than 7" can the rim be before it goes further out than the fenders? And what about the inside of the rim, can 8,5" or 9,5" be mounted without the use of spacers?


Thank you for any replies..


Daniel N, New member

mista808

do you have any idea what the offsets of the rims you are trying to put on are...?

shonn

iTrader: (1)

Well I have 19x9.5 +45 fronts and 19x10 +43 rears. And this is what they look like. OH yea I'm slammed on coilovers too.

geeznuts

iTrader: (14)

Im on 19x8.5 +38 F & 19x9.5 +40 R w/cut tanabe DFs no problems

Daniel N

Sounds good
English isn't my first language ... By offsets do you mean the ET measurement inside the rim.?

PureDrifter

iTrader: (10)

yes.

and the widths are fine, for a good agressive fitment without MASSIVE work involved, look for something between +20 and +25. ( you will have to roll the fenders and maybe give a slight pull)

Brandicus

iTrader: (6)

Agreed, just you will only need a pull if your afraid of camber.

LiCelsior

iTrader: (32)

wth u doin off road brandy

Brandicus

iTrader: (6)

lol I had to drive reallllly slow for that one. I was trying to show a fitment shot.
when you take a photo from the side above it doesnt show how sunken in the wheel is with a high offset.

see? heres a +45 offset wheel.


btw those are 18s

19psi

i ran 9" in the front and 10" in the rear with +24 offsets on both. front was fine, rears needed a roll. looked awesome.