loveMyLs

hi there,

Im looking for a diagram for the CHILD RESTRAINT SEAT TOP STRAP BRACKET INSTALLATION for 1990 LS400 (Celsior C Type - F Package). I imported this car from Japan but unfortunately didnt come with owners manual. Apparently, the diagram is located on pg 61 of the manual. I have taken pics of the parcel shelf where i think the anchor point should go. I just need to make sure I'm right.

loveMyLs

here's the shot of the left side

loveMyLs

here's the center...

loveMyLs

and here's the right side...

Lextreme

I have two kids and understand your needs. The US Spec owner's manual does state the three tethers. Lexus sell a kit for that. I dont remember if the kit comes with three hooks or one hook.

I can take some pics if u r interested.

loveMyLs

I would really appreciate it if you could take pics or scanned page of that section. Many thanks!

Lextreme

Here are some pic. I installed two kits. I removed the middle one because the baby seat were sliding everywhere.

Lextreme

Here is another hook attach to a infant seat.

Lextreme

Here is the middle one. Removed......

Lextreme

A closer look at the hook.

loveMyLs

thanks heeps for the pics! its been a big help...i finally done it!

Lextreme

FYI,

I hope u didnt remove the carpet to install the hooks.

loveMyLs

I just had to cut 3x25mm holes on the parcel shelf for the anchor point kits. Unfortunately mine wasnt pre-welded i had to put custom made plates as anchor point. Here in australia we have to install this anchor points and an unleaded fuel restrictor in order to register an imported car. Thanks very much for your help.

Lextreme

That is too bad. The US Version is pre-drilled.

psls400

How's it going.

Good to see a fellow Aussie CL member.

I'm about to purchase a type C Celsior without the leather and was wondering what mods you have done for compliance and how much $?

I am an enthusiast and let me know if I can be of any help.

Cheers
psls400