Confused on LED for Fog and DRL for 2012 RX350
#1
Driver School Candidate
Thread Starter
Join Date: Feb 2012
Location: Tampa, Florida
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
Confused on LED for Fog and DRL for 2012 RX350
I want to put LED to the fog light, understand that not much light but i have enought from low beam. For this fog, I can just plug in and good to go right? No need module or resistor right?
For high beam that also use for DRL, if installed LED, some say need the module to prevent from flickering, some say don't need, just plug and play.
Anyone installed LED for DRL without module/resistor? If need the module, which is the right one to buy? Thx.
For high beam that also use for DRL, if installed LED, some say need the module to prevent from flickering, some say don't need, just plug and play.
Anyone installed LED for DRL without module/resistor? If need the module, which is the right one to buy? Thx.
Last edited by Huynh9999; 03-03-12 at 07:07 AM.
Thread
Thread Starter
Forum
Replies
Last Post