Kappy you were correct.
First side took longer as I ended up removing too many screws.
Second side took 10 minutes.
You need a flat head screw driver.
Loosen the top screw under the wheel well 90 degrees.
Once the screw is out pull up on the clip and push back the fender liner.
Leave the 2 similar screws below alone and there's a push clip that you gently pull out with you flat head.
Replacing this is a little tricky.
You can now pull away the liner and get to the bulb.
I installed h11 bulbs from http://hidpowerhouse.com/shop/gs-hig...es-h11-bulb-5/
They look a lot better.
I will post pictures when i get a chance.