amoney805

iTrader: (1)

I've been looking for a high quality color matched frame for my ultra white Is but I can't seem to find one. I'm also considering black but not sure how the contrast will look. Anyone with pics let's see your set up.

dbs600

I bought these for my incoming Grey IS:



They're really high quality and will look good on White too!

John510

My frame says :

EAT MORE PIZZA

Mountain Mikes

amoney805

iTrader: (1)

Those look nice. I just want to see what it looks like on a white car before I order.

JWadle

I found these in black pearl for my UW F-sport: They match the black pearl emblems from Sewell.







The frames are the Ultra Z model from here:

http://www.jewelryforcars.com/Frames...duct_make.aspx

They are plated zinc alloy and very high quality.

amoney805

iTrader: (1)

^^^^^Goes good with your emblems.

abcsoup

The black frame looks really great. Definitely helps the front plate blend into the grille, and the white Colorado mountains actually match nicely with the ultra white paint. Nice!

vbx

Looks like the frame doesn't cover the 2 holes on the bottom plate. I think I'll get the one with a thicker frame on the bottom to cover the holes.

KeyserS

Or glue a couple pieces of cheap steel to the back of the plate behind the holes so that you can fill the holes and then paint them white.

KeyserS

Nice looking car. I lived in the Denver area for many years up until a few years ago. I had a silver Audi and didn't like the green on the plate. I took a black permanent marker and turned the green parts a ver dark, dark green, almost black. It was obvious, but no cop ever bothered me. They don't look at the front plate anyway, because all the ever look for is the stickers on the rear plate. But I did that to both front and back. I would be really, really annoyed if I had the lovely F-Sport grill and had to put license plate on the front. I swear that I would cut it down so that all the extra space at the top is eliminated. I would probably even cut off the "colorado" on the bottom, leaving just the number and a minimal white border. You would have to fabricate a frame as well, but that would not be difficult. I doubt if you would get hassled as long as you don't get pulled over for a moving violation. And even if you got hassled, no reasonble cop would ticket you for it, but would probably only tell you to got to the DMV and get new plates. That's the worst that would likely happen, but not even that is very likely, and even if it happened, it wouldn't cost much.

JWadle

I considered the version with the wider bottom, but it would cover the state stickers (if they are placed correctly) unless you paste them much higher on the plate.

I may do something like white plugs to cover the bottom holes in the plate.

Navy266

Hey guys I'm looking for some good license plate frames and the two I like the best I can't seem to find anywhere! Anyone know where I can find either of these frames?

Navy266

Or the bottom one

Alius

I personally have this one if you're willing to spend some $$ on a license plate

https://www.clublexus.com/forums/is-...ate-frame.html

Navy266

I've been looking at that one and am trying to decide if that will look good on atomic silver with the white lettering