Fitting Enkei wheels
#1
Pit Crew
Thread Starter
Fitting Enkei wheels
I found a older set of NT03 from my old evo. The size is 18x9.5 with a +40 offset.
I prefer to run non staggered wheels since it's easier to rotate and not worry about flat tire issues. Will these work mount of my IS350 F-sport without any rubbing issues?
I prefer to run non staggered wheels since it's easier to rotate and not worry about flat tire issues. Will these work mount of my IS350 F-sport without any rubbing issues?
#4
At some point, I'd like to square my set up too. Like you, curious to see what wheel/tire size fits up front.
#5
#6
Driver
iTrader: (1)
If all goes well, I'll be getting a 350 RWD next weekend. Once it's home, I plan to put on the tires and wheels off my current STI which are Enkei PF01 18x9.5+45 with 265/35/18 Dunlop Star Specs just to see how they fit. I don't think the wheels will look good on the IS, but I simply want to see how they fit.
#7
Pit Crew
Thread Starter
People are telling me that it's going to look awkward being too far extended and I may need to roll my fenders with 9.5" wheels on a squared setup
Trending Topics
#8
Driver
iTrader: (1)
I just tried to mount some 18x9.5+45 wheels with 265/35 Dunlop Star Specs on my 350 F sport and they won't work on the front because the inside of the tire hits the knuckle. I spaced them out with 7mm of washers, and it barely cleared. With the spacers, they were poking out quite a bit. I should also mention that the Star Specs usually run wide compared to other tires from what I've read.
The rears, on the other hand, didn't look too bad.
The rears, on the other hand, didn't look too bad.
Thread
Thread Starter
Forum
Replies
Last Post
vital
IS - 3rd Gen (2014-present)
4
05-12-17 10:43 AM
nulex1
IS - 3rd Gen (2014-present)
3
07-28-16 04:05 PM