Searched and searched.. no luck. Aux-in does not work.
#1
Driver School Candidate
Thread Starter
iTrader: (1)
Join Date: Feb 2015
Location: wa
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Searched and searched.. no luck. Aux-in does not work.
hello everyone! new the fourms here, but ive done my research and still havent found a solution yet. I recently bought a CPO 2007 is350, and everything has worked perfectly on it. I bought a nice aux chord for from best buy which worked great for a couple weeks. One day, all of a sudden i wasnt able to switch over to aux mode when i press the aux button, all it shows is "no cd" keep in mind, i went out and bought a brand new aux chord to test it out. Does anyone know what i did wrong or how i could fix this? Did i do something to short/damage the aux input?
Trending Topics
#9
Driver School Candidate
Thread Starter
iTrader: (1)
Join Date: Feb 2015
Location: wa
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
So i tried having lexus look at it, but it will not be covered under the cpo warranty. So i decided to dianose it myself again. This time I tried using an aux cord from my gfs car and.. it started working. Turned off my car, tried it again, stopped working. and now it has stopped working completely again.
#12
Driver School Candidate
Join Date: Jul 2015
Location: Washington
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
How I fixed this with my '09 is 250
I had the same issue with my newly purchased is 250. What worked for me was to connect my phone to the aux cord & turn the music on while the car is off... And then turn the car on. The music should start to play then.. Well Hopefully!
#13
Pole Position
iTrader: (7)
Similar Issue
I have a 06... The AUX started to go in and out.. 1st time I replaced the cable, AUX worked for a day, I thought it might be the AZ sun the did something to the cable.. so I bought a new cable at Best Buy... Same issue where I pug in the cable and the AUX works fine.. within a day and a half the AUX stopped working.. I'm on the 3rd cable.. Everything works fine when I place a brand new cable in it.. but it'll stop working after a day or two..
I'm thinking I may need to replace that entire connector?
I'm thinking I may need to replace that entire connector?
#15
its fairly simple. plastic pry tool should pop it out then its just a plug. if you don't have a plastic pry tool a flat screwdriver with a rag over it usually does well but i have seen the screwdriver pop through and scratch the console liner a few time
The following users liked this post:
Wisdom (09-18-21)