is250fsprt

I found a good spot up front but not the rear. Im trying to replace my differential fluid this weekend and need to know where a good spot is. I tried the pinch weld but they bend.

heyarms

iTrader: (5)

I put them along the sides behind the side skirts, that area will bend but no one sees it so its been bent flat and the jacks rest there no problem.

scott1256c

I use my jack stands at the pinch welds, but turn them sideways and along the inside of the pinch weld. I tried using a block with a slot cut out, but that was more trouble than it was worth. If you feel under there, there is some plastic near the wheel well. I try to make sure I stay just off of that with my jack. There isn't a lot of room under there for a hydraulic jack and a jack stand. So the stand goes pretty close to the jack. If you use the jack that comes with the car, you should have more room.

ISland350

Same as Heyarms but I use cut 2x4s to enhance contact...

Gville350

iTrader: (10)

Jack the rear from the diff itself.

Sffd103

iTrader: (16)

Or you can get some of these. http://shopfigs.com/v1/index.php?rou...product_id=188

metaleckz

iTrader: (9)

Or this
http://jmcautomotiveequipment.com/tuxedo-tp9kf-9-000-lb-two-post-floor-plate-symmetric-lift/?utm_source=Google&utm_medium=cse&k=165306&gclid=CLic7braysECFYdufgod_LEAYA