dfwjohnd

iTrader: (6)

Obviously this is not an ideal situation to be doing this; but I feel much better about this than running a spacer.

I know many of us are running this size in the front, how much have you shaved to make it fit? I'll get an exact measurement tomorrow, done messing with it for the day.

BoyOhBoy

iTrader: (9)

Or you can throw in a megan upper control arm! Unless you really hate camber that much. Heard spacers can be dangerous.

Sffd103

iTrader: (16)

Camber arm won't work. I assume your wheels won't fit over your caliper. I have heard of prope doing this but I've seen the caliper rust and it doesn't look nice after its on. People run spacers but its bit or miss. If say get wheels that fit right.

Gville350

iTrader: (10)

How thick of a spacer might you need to run? You can figure this out by getting a box of washers that will fit over the wheel studs, measure a single washer thickness, and stack washers onto the studs until you reach the needed spacer width to clearance the calipers without issue. If 5mm or less, just run a spacer.

Toster24

What disk are the wheels? Might just need a 5mm to clear depending