When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Use a hose clamp from home depot and use it around the hangers. Added benefit from using them is that you can pull your exhaust up higher if you slam your car and itll keep your exhaust from bouncing when you hit a dip at speed.
Use a hose clamp from home depot and use it around the hangers. Added benefit from using them is that you can pull your exhaust up higher if you slam your car and itll keep your exhaust from bouncing when you hit a dip at speed.
Thanks for the tip! Looks a lot better now. I should have got a smaller hose clamp but oh well. I'm just glad it's even.
do you remember what size clamp you used? 2'' maybe 3'' clamp? thanks
Sorry tmf2004. I was lucky had one lying around and I didn't measure it. As you can see on my photo I had a lot of excess hose clamp after tightening so mine was pretty big. You can definitely go smaller. The hose clamp that I used was from my old intake pipe from my civic.
Depending on where you plan to put it on, just make sure the size you get is slightly bigger than the rubber hanger so you don't have excess hanging like I do. If you do, I'm pretty sure you can cut the excess off. Hope that helps.
Sorry tmf2004. I was lucky had one lying around and I didn't measure it. As you can see on my photo I had a lot of excess hose clamp after tightening so mine was pretty big. You can definitely go smaller. The hose clamp that I used was from my old intake pipe from my civic.
Depending on where you plan to put it on, just make sure the size you get is slightly bigger than the rubber hanger so you don't have excess hanging like I do. If you do, I'm pretty sure you can cut the excess off. Hope that helps.
thanks, picked up some 2.5'' clips this morning at Home Depot.. Trying this out tomoroow..
installed a clamp on the passenger side and worked perfectly... the driver side is not moving much so i might have to lower passenger side a bit or fit another avenue for the drivers side...
ended up using 2 clamps on the drivers side and now both sides are perfect.. didn't want to lower the passenger side as i like the look and less gap between the exhaust and bumper...
ended up using 2 clamps on the drivers side and now both sides are perfect.. didn't want to lower the passenger side as i like the look and less gap between the exhaust and bumper...