"JDM" Side Markers
12-18-12, 10:37 AM
#20
Racer
iTrader: (7)
Join Date: Jun 2007
Location: California - Bay Area
Posts: 1,305
Likes: 0
Received 2 Likes
on
2 Posts
couple of the US members have done this already in the past...
requires a precision hole to be cut on the fender since the jdm turn signal housing only allows about 2mm allowance before the hole can be seen outside of the edge.
do a search and you can find some old posts regarding this.
im pretty sure i have another set laying around somewhere at home.
i had them on my is350 sedan before.. If i remember correctly the location was either 14.5" or 16.5" from the bottom of the fender and 3" from the side.. and i believe the "JDM" way is to angle the sidemarker to follow the lines of the car.
You gonna need a dremel, steady hands, and a lot of patience. GL
requires a precision hole to be cut on the fender since the jdm turn signal housing only allows about 2mm allowance before the hole can be seen outside of the edge.
do a search and you can find some old posts regarding this.
im pretty sure i have another set laying around somewhere at home.
i had them on my is350 sedan before.. If i remember correctly the location was either 14.5" or 16.5" from the bottom of the fender and 3" from the side.. and i believe the "JDM" way is to angle the sidemarker to follow the lines of the car.
You gonna need a dremel, steady hands, and a lot of patience. GL
Last edited by ISCjonny; 12-18-12 at 11:12 AM.
Or am I just horribly mistaken? (It wouldn't be the first time)
12-19-12, 05:27 AM
#30
Driver
Join Date: Jan 2012
Location: Toronto, ON
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts