2011 "korean" Bodykit
05-25-12, 11:05 AM
#78
Pole Position
Thread Starter
@ mjh09e : it came up to a grand total of $550, diffuser + prep + paint + install, it might cost you less in the states, here in Canada, especially where I live, they heavily charge you for bodywork. 
@ Muggy : I added those red reflector, I actually like it alot that way. I didnt bought the front lip yet, i'm still debating between the one that goes with this kit or the JC Sportline one. I'm thinking JC front, INGS side, and INGS rear <- it will be cutted just for the rear side so it leaves the middle with the diffuser as it. Kind of hard to explain but it will give a unique look.
@ ZeroSeVen : I will take some photos tonight when I will meet with some of my friends and Ill try to post them tomorrow
. I requested my bodyshop guy to put some screws instead of just using the 3m tape that came with it. But the seller told me that the 3m could have been enough. I was too afraid of loosing the diffuser while driving lol
@ Muggy : I added those red reflector, I actually like it alot that way. I didnt bought the front lip yet, i'm still debating between the one that goes with this kit or the JC Sportline one. I'm thinking JC front, INGS side, and INGS rear <- it will be cutted just for the rear side so it leaves the middle with the diffuser as it. Kind of hard to explain but it will give a unique look.
@ ZeroSeVen : I will take some photos tonight when I will meet with some of my friends and Ill try to post them tomorrow
. I requested my bodyshop guy to put some screws instead of just using the 3m tape that came with it. But the seller told me that the 3m could have been enough. I was too afraid of loosing the diffuser while driving lol
Last edited by toony15333; 05-25-12 at 11:35 AM.
05-25-12, 11:20 AM
#79
Hmmm...I really do like the look of that diffuser, but really wish it went all the way around and lowered the sides more. I was waiting for pics of this to finally pull the trigger on a rear lip...but now I'm even more unsure of what to do haha! Thanks for being the tester and I'm definitely in for more pics!
05-25-12, 11:37 AM
#80
Pole Position
Thread Starter
@ Trza : yeah i wished it was more smooth at the edge but im thinking of getting a ings rear lip and just use the side of the rear lip and cut off the middle section so it hides the edge of the diffuser nicely
04-06-13, 03:59 PM
#82
update: I try to test fit it, and it doesn't seem so bad, there is a 5mm gap at each end side, but nothing a bodyshop cant make it fit.Unfortunately, I couldn't snap a picture, I was alone trying to test fit it so yeah, but it's going in in a bodyshop next week, so now im debating if I keep the same color pattern they suggested ( sfp and black out the fin area ) or go full black, i think it will looks like a wald rear bison on isf, what do you think? 
Thread
Thread Starter
Forum
Replies
Last Post
