bogohead

iTrader: (1)

i got a tab deletion from being to low and now my bumper and fender dont look good not being held together, i saw some people with a piece that goes on the outside of the fender and bumper to hold it together. does anyone know what this is called? where i can buy it?
i know i saw it on the cl member "dangys" car.

JoshIS408

iTrader: (11)

http://www.google.com/search?rlz=1C1...w=1366&bih=667

Gville350

iTrader: (10)

SSR quick releases probably :

bogohead

iTrader: (1)

thanks!
when i put it on how should i make the hole?
with just a drill?

Gville350

iTrader: (10)

Yes, drill a pilot hole a tad smaller than the width of the screw itself and tighten her down with a hand screwdriver. With using a cordless screwdriver you might over torque the screw and strip the hole.

GL!

o7iS250

iTrader: (1)

I've been looking for these as well! Jus trying to find em in gold.. are the metal? or cheap plastic..

CarbonDtls

iTrader: (4)

I think when it comes to either raising your car up a bit or using some tacky fasteners on a Lexus I would raise the car up.

o7iS250

iTrader: (1)

it costs to ride low, and I'll do whatever I gotta do to STAY low unless my car is gonna somehow total itself because im tuckin all 4 corners but to each their own.