body tolerance
#1
Driver School Candidate
Thread Starter
body tolerance
My search has begun for an IS 250 Manual. Today, I took a close look at one. I noticed that the bumper cover and fender intersection on the driver's side was off by half a 2-4 mm. I found a 350 today too, and it seems it's intersection was also off by the same amount. No other body panels were off.
How's the tolerance on your body panels?
I am also a little suspicious that the white paint is a little off on the bumper cover as well.
How's the tolerance on your body panels?
I am also a little suspicious that the white paint is a little off on the bumper cover as well.
Last edited by retaj; 07-04-08 at 05:56 PM.
#7
That's the nice (or bad) thing about white paint...it's really hard to match. Especially when it has pearl.
If you are buying used, you will almost always be able to tell if there is any paint work. On that same note, it sucks when you want to paint a non-factory lip, spoiler, etc.
If you are buying used, you will almost always be able to tell if there is any paint work. On that same note, it sucks when you want to paint a non-factory lip, spoiler, etc.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post