DIY - TPMS Canister/Pipe Bomb
02-09-16, 05:24 PM
#123
Pole Position
Join Date: Mar 2015
Location: WA
Posts: 258
Likes: 0
Received 0 Likes
on
0 Posts
03-19-16, 09:55 PM
#124
Rookie
Join Date: Feb 2012
Location: Phoenix, AZ
Posts: 76
Likes: 0
Received 0 Likes
on
0 Posts
Just made one today myself. After researching a bit, I found this article.
http://www.local10.com/news/device-b...toy-police-say
Oops. I guess it really does produce a scare. haha
http://www.local10.com/news/device-b...toy-police-say
Oops. I guess it really does produce a scare. haha
02-24-17, 08:06 AM
#125
I know this thread is a bit old, however I still hope someone can help. When putting the sensors in the canister, do they need to have the valves in them? I did the spare tire trick, but I put the 4 sensors inside without putting the valves back in the stems when I took them out to empty the tire of air. So I still have the " Check System" light and yellow tire light on.
02-24-17, 01:56 PM
#126
Best bet to put the valves. I tried this trick many moons ago and I could not get the canister to seal 100%. I ended up disabling my TPMS, this was for my SC though.
10-13-17, 11:34 PM
#127
Driver School Candidate
Join Date: Sep 2017
Location: wa
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
I just did this today. yes it worked. I replaced my stock rim with aftermarket. i put it with the reserve tire at the back hiding there. I will check if the psi will go down in a few months...
I put 2 towels in between the 4 sensors inside the canister.
I put 2 towels in between the 4 sensors inside the canister.
Thread
Thread Starter
Forum
Replies
Last Post
