Motorized nav housing illumination
11-25-10, 03:40 AM
#1
Driver
Thread Starter
Join Date: Mar 2003
Location: International
Posts: 171
Likes: 0
Received 0 Likes
on
0 Posts
Motorized nav housing illumination
Hi All
I have just retrofitted a touchscreen nav into a 7" motorised housing (pics soon). All is working except I can't get the tilt and open close buttons to illuminate at night.
Anyone know which wires to tap into from the housing to thee cd player or seat heater harness
I have just retrofitted a touchscreen nav into a 7" motorised housing (pics soon). All is working except I can't get the tilt and open close buttons to illuminate at night.
Anyone know which wires to tap into from the housing to thee cd player or seat heater harness
Last edited by psls400; 12-05-10 at 03:36 AM.
12-04-10, 08:10 AM
#2
I didnt have the navigation harness so i soldered to the pins on the nav housing. hope this helps
RADIO SIDE plug-------->NAVIGATIOn LARGE SOCKET
pin 1 is power-------goes to top right of socket(pin1)
pin 11 is acc--------bottom right of socket(pin 14)
pin 20 is ground-----bottom left of socket(pin 25)
pin 2 illumination (+)------above ground(pin 13)
pin 12 illumination (-)------next to power(pin 2)
RADIO SIDE plug-------->NAVIGATIOn LARGE SOCKET
pin 1 is power-------goes to top right of socket(pin1)
pin 11 is acc--------bottom right of socket(pin 14)
pin 20 is ground-----bottom left of socket(pin 25)
pin 2 illumination (+)------above ground(pin 13)
pin 12 illumination (-)------next to power(pin 2)
Thread
Thread Starter
Forum
Replies
Last Post
3rdelement
IS - 1st Gen (2001-2005)
7
06-06-09 08:56 PM
