KOKISF

How you guys put the cover back on the head lamp , what did you do ? Pics ? Searched but no succes

Justind27

iTrader: (6)

The same way it came off would be my guess (not being a smartass, I only swapped mine for nokya stage 2's)

PiusGS

iTrader: (1)

Its impossible unless you drill out holes and run your wires then silicon, I installed vled drl's with a decoder. No way for the cover to go back run. Ive been running it like this for a month now. No moisture or any leaks..

KOKISF

Finally some one that knows what im talking about! Thanks thats what im going to do!

dcguy

I had some led drls i bought from ijdm toy and they came with an incredibly bulky decoder. I split the plastic case and was able to tape up the circuit board inside and stash it inside the headlight. Have some patience though it takes some finessing. ran them for a few years no problems, and never had to drill the cover, sealed up just fine

JDMV8

iTrader: (6)

Note: you WANT to use the cover. If you decide to drill through it, make sure it is leak-proof (I would recommend silicon paste). The lights would accumulate moisture eventually, and you'd be ready to buy new headlights...or the MY11'+ lights

KOKISF

Already have 2012 hl

atl08isf

iTrader: (1)

I bought mine from ijdmtoy and they had 2 options of decoders, the cover would not fit back on with the bulkier decoder so I sent it back and requested the slim decoder. they ship you the bulky 1 by default, you have to request the slim one, the cover goes back easily with the slim decoder.