Lexus isf ( i/h/ex) vs 335i jb4 with full bolt on
#31
Lead Lap
iTrader: (3)
Join Date: Mar 2013
Location: FL
Posts: 585
Likes: 0
Received 0 Likes
on
0 Posts
I know it's slightly off topic, but I don't think Borla makes that much of a difference from Joe-Z. Different conditions on the dyno. Also Caymandive's and toothdoc's excellent times are mainly attributed to experience and properly preparing the car, not the choice in power mods (ie. sikky vs ppe, joez vs borla vs issforged).
#32
I know it's slightly off topic, but I don't think Borla makes that much of a difference from Joe-Z. Different conditions on the dyno. Also Caymandive's and toothdoc's excellent times are mainly attributed to experience and properly preparing the car, not the choice in power mods (ie. sikky vs ppe, joez vs borla vs issforged).
#34
Racer
Yeah I agree those charts give you a general idea, and as for the difference between the two exhausts yes I agree it should be minimal but those graphs can make you think otherwise.
I'm sure I've seen a few dynos with Joe-z hitting close to 400, but can't remember where.
I'm sure I've seen a few dynos with Joe-z hitting close to 400, but can't remember where.
#35
11 Second Club
iTrader: (2)
Yeah I agree those charts give you a general idea, and as for the difference between the two exhausts yes I agree it should be minimal but those graphs can make you think otherwise.
I'm sure I've seen a few dynos with Joe-z hitting close to 400, but can't remember where.
I'm sure I've seen a few dynos with Joe-z hitting close to 400, but can't remember where.
#37
Driver School Candidate
Join Date: Jan 2014
Location: sa
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Hi all
I have a ISF 2010 model thats going out off plan next month 60000km .
want to know if i must sell or keep it.
does any one have any problems on this motor (does it give problems )
regards
I have a ISF 2010 model thats going out off plan next month 60000km .
want to know if i must sell or keep it.
does any one have any problems on this motor (does it give problems )
regards
#38
I will say it depends on driver and if you manage to
Keep the guy making your race
I put my car 3 gear 4500 rpm , and ive beat them by half a car or one car! They pull strong but we have better top end. My mods are ppe, iss forge qes,silicone intake section , and everthing else stock. There are only a few that seemed to be faster but they didnt raced
Keep the guy making your race
I put my car 3 gear 4500 rpm , and ive beat them by half a car or one car! They pull strong but we have better top end. My mods are ppe, iss forge qes,silicone intake section , and everthing else stock. There are only a few that seemed to be faster but they didnt raced
Last edited by KOKISF; 08-08-14 at 09:52 AM.
#39
Glad my car had Borla to begin with, after adding PPE headers car feels like a much larger beast now especailly in sport mode. I may just squash plans for adding LSD & go for the tune if it ever gets released that is.
#42
I have the Borla and thinking of adding ppe. I've read by adding the headers you remove some of the low rpm drone from the borla? I know the combo sounds amazing.
Thread
Thread Starter
Forum
Replies
Last Post