ISF 1 piece drive shaft why not?
#17
Instructor
iTrader: (6)
Well I'm happy to say that after talking with a guy through email a 1 piece shaft will be approximately $1400.00, not sure if it includes shipping. I just need to measure the length from 3 bolt flange on diff to the 3 bolt flange on the transmission and they will produce a product. Maybe we can throw a group buy or something? Any help from mods on coordinating this on the forum would be rad, I've only been a purchaser in a group buy on a different forum long ago. -justin
#18
Lexus Champion
iTrader: (9)
I sent a query to the Driveshaft Shop and just received the following reply:
So how do we get this thing rolling? Anybody have a driveshaft they can spare
Lou
all i need is the dimension from one, just to be clear it will not be much lighter but what you will notice is allot
you see cars with Guibo's and a hanger have allot of movement before the car moves. when you step on the gas
the front Guibo twists, then the torque moves down the 1st shaft and then the hanger bearing rubber moves up
about .600 to .700 then down the back shaft to the back Guibo and more twist. only after all of this will the car move
with the Carbon shaft (or aluminum) there will be direct movement, the car will feel more athletic or connected to
the gas pedal. its a very noticeable thing.
The Driveshaft Shop
4530 Southmark Dr.
Salisbury NC 28147
800-564-2244 PH
704-633-2385 FX
"We specialize in the impossible"
you see cars with Guibo's and a hanger have allot of movement before the car moves. when you step on the gas
the front Guibo twists, then the torque moves down the 1st shaft and then the hanger bearing rubber moves up
about .600 to .700 then down the back shaft to the back Guibo and more twist. only after all of this will the car move
with the Carbon shaft (or aluminum) there will be direct movement, the car will feel more athletic or connected to
the gas pedal. its a very noticeable thing.
The Driveshaft Shop
4530 Southmark Dr.
Salisbury NC 28147
800-564-2244 PH
704-633-2385 FX
"We specialize in the impossible"
Lou
#23
Instructor
iTrader: (6)
Spoke some more today, I'll be likely just measuring mine on the car so I get more exact measurements do to variances that can't be taken account for while one is removed. These will take about 3 weeks for the initial r&d and then I cannot tell you how long it would be. I managed to scrape up last min $ to do this and basically has came down for needing the length dimension. I'll post more as it comes along.