Replacing driver's side door handle
06-10-14, 11:51 PM
#1
Replacing driver's side door handle
Other than removing the door panel to unplug the electrical connector to the door door handle, is the rest of the door handle replacement similar to the video below? or is it different for the 2g is models?
Any help greatly appreciated.
Any help greatly appreciated.
06-11-14, 12:10 AM
#2
I had to remove my handles when I wrapped my car. You also need to remove the panel to remove another torx bolt that holds in the main handle as well. You can use a torx, however a hex works just fine too. It should be pretty straight forward otherwise.
These are the two screws you need to remove
These are the two screws you need to remove
06-11-14, 12:19 AM
#3
I had to remove my handles when I wrapped my car. You also need to remove the panel to remove another torx bolt that holds in the main handle as well. You can use a torx, however a hex works just fine too. It should be pretty straight forward otherwise.
These are the two screws you need to remove
These are the two screws you need to remove
How long would you guesstimate the job to be? hours? mins?
Nice wrap on your isf.
Thread
Thread Starter
Forum
Replies
Last Post
sallydrive
IS - 2nd Gen (2006-2013)
1
08-14-12 07:27 PM
