OEM Axle back exhaust trunk fitment
11-05-13, 11:37 AM
#1
Driver
Thread Starter
OEM Axle back exhaust trunk fitment
Question for owners who had an axle back installed at a shop. Does the oem rear section fit into the trunk?
I'm debating between bringing my car to a shop to have it installed or doing it myself. Any tips for a DIY? I bought my exhaust used and may not have installation instructions. Thanks!
I'm debating between bringing my car to a shop to have it installed or doing it myself. Any tips for a DIY? I bought my exhaust used and may not have installation instructions. Thanks!
11-05-13, 01:07 PM
#3
Lexus Test Driver
I dont have an F but it doesnt even with the standard IS. Its all one piece so you cant even separate the muffler and put down the back seat and move it from there. I ended up doing it at home so i can just dump the OEM in the garage
Kind of annoying to have a full one piece 2 muffler exhaust.
Kind of annoying to have a full one piece 2 muffler exhaust.
11-06-13, 05:57 AM
#5
Pole Position
Join Date: Dec 2010
Location: Florida
Posts: 287
Likes: 0
Received 0 Likes
on
0 Posts
When I had my cat back installed, I was just barely able to fit both pieces (stacked on top of each other) into my Cayenne with the back seats down. I think I remember an old 2IS thread a while back where someone jammed the stock exhaust into the cabin, but had to stick a portion of it out the sunroof.
Thread
Thread Starter
Forum
Replies
Last Post