When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
most likely a bunch of screw on the bottom. Its super easy to install. no need to take it to a professional. only hard part for me is to make each side identical
most likely a bunch of screw on the bottom. Its super easy to install. no need to take it to a professional. only hard part for me is to make each side identical
A drill template is the easiest way. Make a template for the diffusers, and for the bottom of the bumper and line up the holes. Don't try to line up the diffusers with the bumper and drill.
And obviously removing the front bumper will make the task a hell of alot easier.
@DCoolBeans: Not sure. Had a local shop install them for me. I can take a look tomorrow.
Took a look earlier today and saw that the each splitter was attached to the bumper underside through a series of nuts/bolts and self-tapping screws, at nine points on each flipper. Based on this, the overall feel is a very secure fit. Also, I don't believe any two-sided tape was used.
Also, found another pic from the side, from a moderate distance.
Took a look earlier today and saw that the each splitter was attached to the bumper underside through a series of nuts/bolts and self-tapping screws, at nine points on each flipper. Based on this, the overall feel is a very secure fit. Also, I don't believe any two-sided tape was used.
Also, found another pic from the side, from a moderate distance.
that looks really good, nice and clean. understated.