Originally Posted by Rickna

^^ Looks great. I like the molding around the cut-outs.

Originally Posted by occxlr8ed

blacked out headlights

Originally Posted by Jovy11

^^ interesting. was thinking how to do that.

Write up?!

Originally Posted by lobuxracer

OK, since no one else seems to have documented this, I thought I'd do it this afternoon for S&G.



If you don't know how to get to this point of console disassembly, check the nav hack thread for guidance.



The connector is a tad buried, but you can get your hand in there, really! The release is on the front, so it isn't hard to squeeze it and get it disconnected. When you do, it will look like this:



Note the position of the pink and violet wires. They are going to be reversed when we are done. I recommend removing the electrical tape from the end of the condulet and removing the rest of the tape from the wire bundle so you can easily pull the individual wires. Note how it is taped so you can duplicate this when you tape it back up if you want to retain your basic wiring reliability.



This connector has a secondary lock. I thought it was too small to have one, so I hacked up the connector a bit before I realised my stupidity, and there are some ugly marks on the connector now. Avoid my mistake and release the secondary catch by gently prying the small screwdriver slot in the middle of the secondary catch. It will only raise a little bit - about 2mm as you can see in the picture - but it makes all the difference in the world. AMHIK.



Since some have complained about the difficulty of getting pins released, I included a close up of what you are trying to accomplish. The tabs shown in the picture are easy to lift once the secondary catch is released. If you are really ****, you can do what I did and make the tool Toyco recommends for this, or you can just use a 1mm wide tip jeweler's screwdriver to lift the tab.



Here's the tool I made in action. I used a 1.4mm round stainless steel needle from a turkey lacing kit and filed it down to a 1mm x 1mm square, then filed off the point, squared it up and beveled the end as directed in the Toyco documentation. I just inserted it, levered up gently and effortlessly pulled the pins out the back of the connector.


This is the finished product. Note the pink and violet wires are reversed. Put the tape back on the wire bundle and condulet, plug the connector back into the shifter and reassemble the console. The job is finished.

I tested it, and it does indeed work like a charm to reverse the stick's shifting action. As always, I can't be responsible for any damage you might do through ham fisted problem solving (and you can see a bit of mine in the pics if you look close). The saving grace to this is the connector is available from Toyco or Tyco (the original manufacturer) if you really bugger it up.

Originally Posted by 2011slvISF

^^^^where did you get that...i want one!!!