zazzn

So I had a issue with my touch screen not tracking anymore and drew in the contacts like many treads/videos suggest.

Got the ***** fixed, but during testing the metal shaft of the shifter snaked its way though the hole (no bezel attached) and touched the PCB board on my radio. Now my radio will not turn on!? I'm not sure if the damage I did is causing this or if there is a code that is needed to make the radio work when it's been disconnected.

Can anyone snap a pic of the board in reference to my picture so I can see if the shifter knocked off resistor or something. I'll try drawing or soldering on a contact wire but it's VERY small and I think i just screwed my self on this one.

zazzn

Does anyone know if there is a specical code that is needed to turn on the radio if the battery was disconnected?

Pie

iTrader: (3)

No code that I am aware of.

zazzn

ah i had one of the wires wrong because the vias tech..

Got it all working.