The Wait is Over: Lexus ISF CCS-R Arrives in the USA (Live Pics & Video from PPIHC)
#32
Driver School Candidate
iTrader: (4)
Join Date: Feb 2012
Location: Texas
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
I'd take the hood on the CCS-P for sure but for the price Lexus is looking for I doubt it is worth it. I'm sure you could find some similar louvers somewhere and have a good shop fabricate them into the hood for a fraction of the price.
#34
Lexus Fanatic
Thread Starter
iTrader: (10)
Join Date: Nov 2004
Location: Under an IS F since 2008
Posts: 13,441
Received 1,064 Likes
on
586 Posts
Yeup.. Below I linked a dedicated (now) "Locked Thread" discussing the Japan Launch of these parts & the perspective prices of the Lexus IS-F CCS-P = "Circuit Club Sports Parts"
Lexus IS-F CCS-P (Circuit Club Sports Parts) by TRD Japan
But I guess we can use this thread to continue the discussion(s)... (sigh)
~ Joe Z
Lexus IS-F CCS-P (Circuit Club Sports Parts) by TRD Japan
But I guess we can use this thread to continue the discussion(s)... (sigh)
~ Joe Z
Last edited by Joe Z; 06-06-12 at 01:34 PM.
#37
Lexus Champion
iTrader: (9)
Lou
#38
Lexus Fanatic
Thread Starter
iTrader: (10)
Join Date: Nov 2004
Location: Under an IS F since 2008
Posts: 13,441
Received 1,064 Likes
on
586 Posts
My comments did not imply that the rotors were stock in any way. I mentioned the hats and the fact that the front rotors were slotted and the rear drilled as being strange. I did say, however, that the calipers looked like stock F Brembo pieces, but that the pads were probably different. The fronts appear to be six puckers and the rear 2 - like stock. To me, the caliper assemblies look stock.
Lou
Lou
So like I said the Rears are just about as OEM / Stock as you can get..
The Fronts are NOT.. (at all) Calipers or the obvious 2 - Piece Slottled Floating Rotors
See exterior brake fluid transfer line on the bottom of the Brembo Race Caliper..
~ Joe Z
Last edited by Joe Z; 06-09-12 at 12:29 PM. Reason: added "fluid"
#41
@ Joe - Do you know what the circular cutout is for on the right front fender?