shyguyF

I think it will work bc your fenders have been shaved. With 9.5 +35 the outer edge will be 26.5mm sticked out compared to the stock wheels 9" +55. And I think 285 on 9.5" looks better than 285 on 9".

zmcgovern4

iTrader: (2)

I have 19x10 +40 in the rear with 285/30 (basically the same as your 9.5 +35). Fenders are rolled and I only rub on big dips at speed. 99% of the time there is no rubbing.

ljdsong

iTrader: (1)

Look up my post page 938, thats 285/35/18 +35 it rubs at tha edge where the bumper and fendermeets,even my fender rolled and pulled still rubs at the top most of wheel arc. I suggest get the 275 wide tires.

Max16

I want 285/30 not 285/35

Flogrown

iTrader: (1)

I'm running 19x10.5+35 on a 285/30 tire with a roll and slight pull. I only rubbed on the bumper tab, I was tucking with less than an inch from the lip. I raised it up 1/2 an inch and don't hit the bumper tab anymore, so you should be ok.

Durrby

iTrader: (3)

I'm looking at a set of AG M510's on craigslist. The listing says their 20x10 +35 with 235/35's all around. With a stock height car will I encounter any clearance issues? I tried to skim at least the last few pages and it seems I might be good. Seller said he's unsure of fitment with BBK's though.

Flogrown

iTrader: (1)

Durrby you should be good my previous set up was 19x10.5,+16 with a 235/30 tire they were stretched. I was lowered as well and didn't have an issue. Even though you may get 20's I don't see it being that much of an issue. I used to run a set of Weds that was 20's at stock height with the offset of +24 without issues as well with just a roll.

Durrby

iTrader: (3)

Thanks for the fast reply! How about inner clearance, were spacers needed to clear the brakes/struts?

flowrider

iTrader: (9)

We're talkin' 18" vs 19" here. 285/30/19 and 285/35/18 have the same OD.

Lou

Flogrown

iTrader: (1)

No issues with inner strut clearance, I have a set of CCW's that are 13 inch wide that fit as well, they just poke out the sides. I'm kinda a week *****. If I keep the F I might do the Lexon wide body.

ROYALISF

You'll be good. I'm running 20x10 with a 275/30 on all 4. I have the rears rolled and only rub on deep bumps otherwise its fine.

ljdsong

iTrader: (1)

Understand that! You want the 19s and my set up is 18. Im doing my fender rolling and pulling by my self and my previous set up is 275/19 and no problem with pulled and rolled fenders. Im saying your safe with 275. They're saying raised up 1/2 inch, if you have coilovers, but how about if you stock and have passengers. It will rub still. You can get away with the rubbing only if you get a neg camber.

Meraki Autoworks

iTrader: (8)

Meaty..

-Josh

terryvly

iTrader: (2)

perfection

Eminence