Quality interior LED lighting that's close to or slightly brighter than stock?
#1
Rookie
Thread Starter
Quality interior LED lighting that's close to or slightly brighter than stock?
I've been searching and reading LED lighting threads over the past couple of hours and one thing that's common is how much brighter they are than stock lighting. I'm not quite looking for that however. Ideally I'd like to have a quality interior kit or individual LEDs that are at most twice as bright as stock. Does anyone know of LEDs like that? Thanks in advance!
#2
This is the LED lighting package that I found through searching the LED lighting threads.
#3
I recommend getting these. Even though they're cheap they work great.
#6
Rookie
Thread Starter
#7
Driver School Candidate
Join Date: Dec 2015
Location: CA
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Trending Topics
#8
Driver School Candidate
Join Date: Jan 2016
Location: FL
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
#10
Rookie
Thread Starter
Just installed the Philips Vision 194 LEDs on the interior and single trunk light and they look great. Used 13 bulbs total. Not too bright and they do dim. Tried to use the Philips Vision 921 LEDs on the reverse lights but they don't sit fully in the base :/. Guess I'll have to return them.
#11
Advanced
iTrader: (3)
Just installed the Philips Vision 194 LEDs on the interior and single trunk light and they look great. Used 13 bulbs total. Not too bright and they do dim. Tried to use the Philips Vision 921 LEDs on the reverse lights but they don't sit fully in the base :/. Guess I'll have to return them.
#12
Just installed the Philips Vision 194 LEDs on the interior and single trunk light and they look great. Used 13 bulbs total. Not too bright and they do dim. Tried to use the Philips Vision 921 LEDs on the reverse lights but they don't sit fully in the base :/. Guess I'll have to return them.
#13
Rookie
Thread Starter
Ah, thanks again Noeh. I found the review and may give sanding them a try this weekend. Worst case the lights don't work still after the sanding but they were only 20 bucks.
#15
Rookie
Thread Starter
Wasn't any trick when I installed them. I just made sure to pull from as close to the base of the bulb as possible. Maybe try pulling them while wearing Nitrile gloves for some more grip?