DEMONX

Install guide from idata. I hope this helps, is hard to locate the connectors if you don't have an idea on where to start lol

My0gr81

@DEMONX great job reviving this thread. I bought everything I needed and then ended up trading the 2015 IS250 for a 2016 IS300 before doing the install. Can you post where and how difficult it was to get to the connectors? the one that baffled me the most was the PTS button one.

DEMONX

I have work on cars for a while so idk if that made it easy for me but I think anyone can do as long as they know which connectors are the ones you need to work on.

The PTS button part was the easiest one. Here is a quick idea on how to pull the dash piece to get to the PTS button.

First, pull the bottom (marked with O right), work your way around unclipping the plastic dash. Once you have it all off look for connector right behind the push button ( I posted a picture on how the connector looks).

DEMONX

After removing thiis plastic piece, you will need to unbolt the air bag holder (10mm socket require), once you have done that put the air bag in place where it won't be on your way (do not disconnect the air bag)..

DEMONX

Here is a quick video I just uploaded, car stays running for 20 min and after that it shuts off.

specONE

iTrader: (3)

2015/2016 should have ability to remote start from factory, it's only the 2014 that cannot

DEMONX

Very true.

My0gr81

@DEMONX Thank You

@SpecONE, only for US DM models equipped and subscribed to Enform and with the App installed and configured. Once the Enform subscription ends, the ability to remote start ends too. CA and EU models do not have Enform, so no ability to remote start by app or by key fob.

gregerst

Demonx thanks for adding to this thread. This is very helpful. I'm planning to install this at some point in the near future. How long does it take start to finish?

DEMONX

happy to help. It should be an hour maybe two. Drive to Boston and I'll install it for you

G23

I just bought both items. I am going to attempt to install it myself... hope this works...

DEMONX

You will be fine. Is really easy to do

street277

I did the install today using the ADS-ALCA in TL7(RS) firmware and im getting the 5 times parking light error. (tach signal lost) all wires connected except the parking light wires... when i attempt to remote start it gets to ignition and then shuts off. and locks the car. i have a 2014 IS350 F-Sport with NAV. any input will be appreciated. thanks in advance.

gregerst

Were you able to get it all sorted out? I purchased the parts and was going to do the install soon..

gregerst

Have you installed it yet? I'm interested to know how it goes.