2014 IS350 F Sport LED Foglights - DIY
#16
Driver School Candidate
Thread Starter
Join Date: Dec 2013
Location: CA
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Yes, you can wire the relay to be triggered by your existing lights. I just grabbed the parking light wire from the Blind Spot switch. My foglights will turn on and off based on my parking lights.
#17
Driver School Candidate
Thread Starter
Join Date: Dec 2013
Location: CA
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
I guess you could just buy the bezel and try to fit aftermarket but it will not look as clean as the factory. It is expensive but well worth the money... They are LED and not HID or halogen, top quality stuff!
#19
#21
Driver School Candidate
Join Date: Apr 2014
Location: BC
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
Hoping someone can answer this question for me. I bought the kit from Nigel and my installer told me the housing did not include bulbs in the kit, is this true? What bulbs does the kit use?
#23
Driver School Candidate
Join Date: Apr 2014
Location: BC
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
I will get a hold of him and see, I got the entire kit with the projector lenses, but I forgot to check if there were bulbs inside when the package arrived, so I was not sure if they just wired it improperly, or there isn't a bulb inside.
UPDATE:
They wired it wrong and the bulbs are inside....
Last edited by Xenosis32; 07-30-15 at 06:14 PM.
#28
Driver School Candidate
Join Date: May 2016
Location: California
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
Are the fogs adjustable in terms of height? Similar to the headlights in our cars where you can use a philips screw to move up and down the beam patterns.
#30
Resurrecting the dead here, but I've got an install question.
I got Nigel's kit with the oem stalk. The kit also came with an aftermarket switch and separate harness for said switch...
I have the fogs mounted and wired with the included harness, so I have only the yellow wire running through the firewall into the cabin.
My question is, how exactly do I wire the oem stalk? I know from reading, to use pins 10 and 11, but which wire goes to which pin? Do I use that smaller harness even if I'm not using the aftermarket switch?
I have that diagram of the stalk harness from Joe Z, but it shows a white and white/black wire going to 10 and 11...but from where?
Thanks guys.
-Greg
I got Nigel's kit with the oem stalk. The kit also came with an aftermarket switch and separate harness for said switch...
I have the fogs mounted and wired with the included harness, so I have only the yellow wire running through the firewall into the cabin.
My question is, how exactly do I wire the oem stalk? I know from reading, to use pins 10 and 11, but which wire goes to which pin? Do I use that smaller harness even if I'm not using the aftermarket switch?
I have that diagram of the stalk harness from Joe Z, but it shows a white and white/black wire going to 10 and 11...but from where?
Thanks guys.
-Greg