jraiderg

iTrader: (1)

I going with the linea corse 818 19x8.5 +30 front and 19x10+38 rear i going for tire size 225/35/19 front and 255/35/19 is the size right will i have to modify fenders ? Planning to go low on bc coils tuckin tire

Gville350

iTrader: (10)

I have a very similar wheel and tire pkg up front and had to roll the fenders to avoid the tire hitting the fender's wheel liner mounting tabs. Of course you'll need to do a fender-to-bumper tab relocation and might want to even consider pulling out the wheel liners too.

jraiderg

iTrader: (1)

The rears too?

jgr7

iTrader: (1)

I'm running almost the same front with a bigger tire and a little different offset+32 and I have not rolled pulled or deleated any thing. It depends how low you want to go. I do have Megan UCA's and some neg camber. The rears I am running 275/30 with the same width rim and offset no rubbing no fender work only Megan camber arms and a little neg camber. I'm not slamed but about 1 finger in rear and maybe 2+ in front.

Gville350

iTrader: (10)

^Yeah, sounds like the OP and me though are tucking the fronts though; I needed to slightly roll/pull the front fenders. Natural camber, no UCA mods. The rears I've got a quite different setup; so I cannot comment on it.

DaXxJaPxX

so if you were goin for a 1 finger gap all around, no mods would be necessary right? Im looking to go 19x9.5 +35 all around with 235/35/19s , didn't think I needed any fender mods

Gville350

iTrader: (10)

^Could be possible, but again I don't have first-hand experience on that setup with your mentioned ride height. Since I've had my BCRs, I've been relatively "slammed" as some might call it.

srt1

I have similar set up. Mine is rolled in the rear only. I still have my liners in and plan to keep them in.