Problem trying to get a run on the Dyno
11-06-13, 01:39 AM
#1
Rookie
Thread Starter
Join Date: Aug 2013
Location: New Zealand
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
Problem trying to get a run on the Dyno
So I popped along to a Dyno day on the weekend to get a couple of power runs in to see what sort of power I'm getting and how it compares to the 1JZ.
Anyway, hit a few issues with the brakes coming on. From what I've read up on all I should need to do is the pedal dance to turn off VDIM and TRC etc? Right?
Over 30km/h it was applying the brakes, this was after doing the pedal dance thing. Is there something else I need to do? I"ve been told to jumper the ABS service connector.
Car is an '06 (RWD) IS350. Dyno is rolling road 2WD.
Thanks in advance.
Anyway, hit a few issues with the brakes coming on. From what I've read up on all I should need to do is the pedal dance to turn off VDIM and TRC etc? Right?
Over 30km/h it was applying the brakes, this was after doing the pedal dance thing. Is there something else I need to do? I"ve been told to jumper the ABS service connector.
Car is an '06 (RWD) IS350. Dyno is rolling road 2WD.
Thanks in advance.
Thread
Thread Starter
Forum
Replies
Last Post
