DIY: iJDM DRL on IS250/350
#2
Racer
iTrader: (7)
Join Date: Jun 2007
Location: California - Bay Area
Posts: 1,305
Likes: 0
Received 3 Likes
on
3 Posts
you do realize that the cover is there for a reason.. those internal parts get SUPER HOT since it is technically a capacitor. and by just tossing it into your headlamp housing where there are wires and other plastics.. it's bound to melt something... Just FYI..
#4
Driver School Candidate
Join Date: May 2012
Location: NY
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
I installed the exact same set from iJDMTOY last week, but I did not take the decoder apart. I was able to close the plastic cover that protects the headlamp while running the cables to the decoder underneath. It took some time and playing around but i was able to close it.
#5
I installed the exact same set from iJDMTOY last week, but I did not take the decoder apart. I was able to close the plastic cover that protects the headlamp while running the cables to the decoder underneath. It took some time and playing around but i was able to close it.
#6
Driver School Candidate
Join Date: May 2012
Location: NY
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post