IS - 2nd Gen (2006-2013) Discussion about the 2006+ model IS models

2012 Headlamp Has Bubbling Defect Too

Thread Tools
 
Search this Thread
 
Old 10-17-13, 11:12 AM
  #151  
B16da9
Racer
iTrader: (7)
 
B16da9's Avatar
 
Join Date: May 2009
Location: Miami
Posts: 1,882
Received 11 Likes on 9 Posts
Default

Originally Posted by Joe Z
Awesome..!!!

Are there any other headlight wires that run or pass in that area..?

Basically need to see what exactly sits on the underside of that areas that are bubbling..

IF ITS NOTHING, then for sure is either the projector or the chrome rings..


Lexus tried the "eyelashes" or those ribs.. Cause they think the problem was from the SUNLIGHT... But its still hapenning on the updated housings too..

~ Joe Z
No other wire that I can remeber, when I post the picture tonight you'll see what it look like but to give you an idea the inside of the LED is like a reflective dome with the LED diode sitting flat on the bottom shining up to the dome which reflects the lights out.
Old 10-17-13, 11:38 AM
  #152  
Joe Z
Lexus Fanatic
iTrader: (10)
 
Joe Z's Avatar
 
Join Date: Nov 2004
Location: Under an IS F since 2008
Posts: 13,446
Received 1,058 Likes on 586 Posts
Exclamation

Originally Posted by B16da9
No other wire that I can remeber, when I post the picture tonight you'll see what it look like but to give you an idea the inside of the LED is like a reflective dome with the LED diode sitting flat on the bottom shining up to the dome which reflects the lights out.

Maybe that ONE LED gets too HOT

~ Joe Z
Old 10-17-13, 11:49 AM
  #153  
B16da9
Racer
iTrader: (7)
 
B16da9's Avatar
 
Join Date: May 2009
Location: Miami
Posts: 1,882
Received 11 Likes on 9 Posts
Default

Originally Posted by Joe Z
Maybe that ONE LED gets too HOT

~ Joe Z
I still dont think that's the case as I've played around with that damage light to track down the issue. I went as far as plugging the LED board to a power supply the pumps out 12 volts and ran it for hours without getting any bubbling the other issue why I would rule the LEDs out is that the circuit board it seld does not get any where near a temperture that it would start to melt, lift or bubble the paint.
Old 10-17-13, 02:12 PM
  #154  
B16da9
Racer
iTrader: (7)
 
B16da9's Avatar
 
Join Date: May 2009
Location: Miami
Posts: 1,882
Received 11 Likes on 9 Posts
Default

Here are the pictures as promised.









This particular damaged lights had the bubbling I scraped the damaged part off and painted it black from the underside. I was going to apply some reflective tape but I never did as I ended up not using the light.









Old 10-17-13, 02:53 PM
  #155  
SeanIS350
Pole Position
iTrader: (2)
 
SeanIS350's Avatar
 
Join Date: Sep 2010
Location: ON
Posts: 353
Received 1 Like on 1 Post
Default

Thanks the pics.... I'm convinced its not a wire or the LEDs. Looks like its definitely the projector. So it looks like there are 2 options to avoid this issue... 1) projector retrofit, or 2) aim your projector to the sky!.... Lol

For the 2nd option to work... I think you may actually have to disable the AFS feature as well though... This would prevent the projector from pointing lower when there is a car in front of you. I know this may be annoying to oncoming traffic, but hey at least my lights won't bubble
Old 10-18-13, 08:52 AM
  #156  
piguy
Driver School Candidate
 
piguy's Avatar
 
Join Date: Mar 2012
Location: CA
Posts: 35
Likes: 0
Received 0 Likes on 0 Posts
Default

Originally Posted by SeanIS350
This thread is about the 2012+ headlights with LEDs only
Cool, thanks.
Originally Posted by SeanIS350
In any case, I'm going to play it safe and angle mine slightly higher then the stock height. Will let you guys know if I ever get bubbling.... So far none.
Originally Posted by SeanIS350
or 2) aim your projector to the sky!.... Lol

For the 2nd option to work... I think you may actually have to disable the AFS feature as well though... This would prevent the projector from pointing lower when there is a car in front of you. I know this may be annoying to oncoming traffic, but hey at least my lights won't bubble
Please don't encourage people to aim their headlights higher. It's not just annoying, it's primarily a safety issue. When it's oncoming traffic, you're temporarily blinded for a second or two, and when this happens on a curve it's especially dangerous. When it's someone behind you, your rear view mirror is rendered useless.

It's only more annoying than unsafe when that person is just behind you at a stoplight.

People just often don't have any idea how blinding their headlights are because they're never in the OTHER car at night.
Old 10-18-13, 09:15 AM
  #157  
ICU2
Pole Position
 
ICU2's Avatar
 
Join Date: Aug 2013
Location: Australia
Posts: 207
Likes: 0
Received 0 Likes on 0 Posts
Default

This is off-topic but does anyone know if the early 2012 headlights with the eyebrows and flat finish above the LED's have the same LED color as the late 2012 model with a glossy finish above the LED's (Both 2012 versions - just one is current, the other one is the first 2012 version)?
Old 10-25-13, 05:50 PM
  #158  
sthakor92
Driver
 
sthakor92's Avatar
 
Join Date: Jun 2011
Location: FL
Posts: 156
Likes: 0
Received 1 Like on 1 Post
Default

I'm going to go get my 2011 lights ordered tomorrow/verified they're bubbling.. Can someone tell me the latest part numbers? The dealership I go to isn't that great it seems like.
Old 10-20-14, 06:14 AM
  #159  
streetx
Lexus Test Driver
iTrader: (4)
 
streetx's Avatar
 
Join Date: Jun 2011
Location: MA
Posts: 981
Likes: 0
Received 4 Likes on 2 Posts
Default

Just noticed this is on my 12 ISF
Old 04-30-15, 05:10 PM
  #160  
iRock
Lexus Champion
iTrader: (12)
 
iRock's Avatar
 
Join Date: Aug 2009
Location: Bay Area
Posts: 4,125
Likes: 0
Received 1 Like on 1 Post
Default

Anyone had this happen again after the fix?

I noticed about a month ago that mine had the same issue again with the revised headlights. Took it to the Lexus dealer and they do not want to do anything about it. Apparently they called Lexus about it and they told them that they suspect I have aftermarket bulbs since they replaced them already and it happened again. Or the other option they gave was that I park somewhere where a solar panel is beaming on to that one particular spot on both headlights. I can't even begin to explain how crazy that sounds.
Old 04-30-15, 07:31 PM
  #161  
SeanIS350
Pole Position
iTrader: (2)
 
SeanIS350's Avatar
 
Join Date: Sep 2010
Location: ON
Posts: 353
Received 1 Like on 1 Post
Default

That does sound crazy. It's definitely the projectors.

I would like to share a tip since mine have been installed for over a year and a half without any bubbling.

I actually did what I suggested on my earlier post. I have adjusted my lights slightly higher, not to the point they are pointing too high to be distracting to on coming traffic, but definitely higher than my old headlights used to be.
Old 04-30-15, 09:23 PM
  #162  
jennie
Pole Position
 
jennie's Avatar
 
Join Date: Dec 2007
Location: california
Posts: 309
Likes: 0
Received 0 Likes on 0 Posts
Default

For those of you that have the latest updated headlights and have the bubbling defect: how much night driving do you do? Mine are fine but the last thing I want is for them to bubble when my warranty runs out.
Old 05-01-15, 07:46 AM
  #163  
jgr7
Lexus Test Driver
iTrader: (1)
 
jgr7's Avatar
 
Join Date: Jan 2008
Location: Vacaville, CA
Posts: 957
Likes: 0
Received 0 Likes on 0 Posts
Default

I had mine done and they put an older version in and it did it again. Took it back with the part numbers they should have put in and they did it again, this time no issues.
Old 05-12-15, 05:59 PM
  #164  
EDYGRIFFIN
Driver School Candidate
 
EDYGRIFFIN's Avatar
 
Join Date: Dec 2014
Location: az
Posts: 17
Likes: 0
Received 0 Likes on 0 Posts
Default

took mine in today to have the oil changed and brought up the TSB guy said he never heard of it in the IS only on the RX models. Also said the big thing right now for the IS is the sticky dash recall which if applicable will be sent out here shortly.

Told him to give me a minute while I found it and printed it out to show him and then he was looking at the actual lense of the light and said he couldn't see anything. Even though it was perfectly clear and pretty bubbled over. He had the tech look at it and boom he went straight to parts to get the new lights ordered and will be replaced sometime next week!

Hopefully I get the right ones the first time.

Cheers!
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
lexethan
RX - 3rd Gen (2010-2015)
25
05-24-14 05:41 PM
danhtran
IS - 2nd Gen (2006-2013)
7
05-01-12 08:26 PM
Fizzboy7
IS - 2nd Gen (2006-2013)
24
08-03-11 03:20 PM
sears1234
CT 200h Model (2011-2017)
15
08-01-11 11:41 AM
joe80
Car Chat
5
03-28-10 07:34 AM



Quick Reply: 2012 Headlamp Has Bubbling Defect Too



All times are GMT -7. The time now is 09:08 PM.