★★★★★ Offical iForged Owners Thread ★★★★★
#16
Lexus Fanatic
iTrader: (1)
A few people criticized them for being HRE knock-offs, which I think is silly.
They always looked good and recently, there have been no complaints that I have heard.
I hope lots of people post pics cause they are nice looking wheels.
#18
Driver School Candidate
iTrader: (2)
I need to post pics of my car in this post
#21
I'm pretty sure there are a few members here that have or had iForged wheels on their 2IS.
Please share your pics and specs, here are mine:
iForged InSite - Textured Gunmetal
F 19 x 9.0 +35 - 215/35R19
R 19 x 10.0 +35 - 245/35R19
Dropped on Megan LP coilovers + Phantom Cup Kit by Platinum VIP
Rolled front fenders
Shaved rear fenders
Rubs in the front when riding without air, no issues in the rear.
Video courtesy of Rush350:
http://www.youtube.com/watch?v=pM831...1&feature=plcp
Please share your pics and specs, here are mine:
iForged InSite - Textured Gunmetal
F 19 x 9.0 +35 - 215/35R19
R 19 x 10.0 +35 - 245/35R19
Dropped on Megan LP coilovers + Phantom Cup Kit by Platinum VIP
Rolled front fenders
Shaved rear fenders
Rubs in the front when riding without air, no issues in the rear.
Video courtesy of Rush350:
http://www.youtube.com/watch?v=pM831...1&feature=plcp
Those wheels are sick
#22
Lexus Champion
iTrader: (2)
Just a little FYI. I ran the iForged TPMS adapters for a few years. They loosened up to the point that they allowed the sensors to spin and slam against the rims, destroying all 4 sensors. After that experience I had the sensors banded to the rims. So far the bands have held up with no problems.
#23
Lead Lap
iTrader: (21)
Join Date: May 2011
Location: CA
Posts: 569
Likes: 0
Received 0 Likes
on
0 Posts
Just a little FYI. I ran the iForged TPMS adapters for a few years. They loosened up to the point that they allowed the sensors to spin and slam against the rims, destroying all 4 sensors. After that experience I had the sensors banded to the rims. So far the bands have held up with no problems.
#24
Lead Lap
iTrader: (21)
Join Date: May 2011
Location: CA
Posts: 569
Likes: 0
Received 0 Likes
on
0 Posts
You need the iForged TPMS adapters to run the TPMS for any 3 piece wheels. Most 1pc wheels have the valve stem hole on the face like the OEM wheels, but 3pc wheels have the valve stem hole on the inside barrel and usually a metal valve stem with a 90 degree bend so the tip comes out the front.
I need to post pics of my car in this post
I need to post pics of my car in this post
Thread
Thread Starter
Forum
Replies
Last Post
Dexterr
IS - 2nd Gen (2006-2013)
691
06-28-20 06:15 PM
RDIS250AWD
IS - 2nd Gen (2006-2013)
125
09-10-14 09:45 PM
SubieChik
IS - 2nd Gen (2006-2013)
8
06-19-14 02:46 PM