DJKIBBLES

iTrader: (4)

are there any secrets to jacking up your car? when i jack my car up i always seem to hit my side skirts and it sounds like its about to crack... and yes i try driving on wood and its still too low to get a clean LIFT... my car isn't even that low i wonder how the DUMPEDDDD cars get jacked up? also can you guys make it to LEXUS without raising your car up for an oil change or maintenance? thanks!

lobuxracer

iTrader: (2)

I made ramps out of stacked 2x10s. Jack rolls under like nothing so I can hit the front and rear jack points and use the floor pan seams for jack stands.

2slow

iTrader: (5)

^+1. Or drive up Rhino ramps and jack it up.

L-S-D

iTrader: (-1)

i get my friend to lift my car as much he cant and i put some wood under and trhen fit the smallest jack i got lol

Proper 350

iTrader: (6)

get a low profile jack..if not then use the hand jack and jack it up till you can fit a hydralic jack under it...iss a ***** but it does the job..

Robs IS250

iTrader: (4)

Drive onto a 2x4 and also use that 1/4 inch elevated garage entrance as a little bit of help to lift the front end more....

B16da9

iTrader: (7)

Sears sells a low profile hydrolic jack that is very handy.

datplayaz

iTrader: (9)

2x4 and a low profile jack, either that or use the spare jack.

xuningshen

iTrader: (1)

^^ exactly

use the spare jack that comes with your car first and then once its high enough put in the low profile jack

venZon

The jack hits my side skirts so i have to use my spare. Even the spare jack slightly hits. I usually jack up the rear by the diff but my exhaust is in the way now.

nmpeter

iTrader: (15)

I use the stock jack to jack it up a little and then use my hydraulic jack. Ramps are too high for me

tnogi

iTrader: (23)

X2 on Low profile jack


toHn

edgeucated

iTrader: (4)

stack 2x4, then stock jack, then i use my hydraulic jack

telmz1

iTrader: (1)

what does everyone do when they need to take their ride to the dealer or mechanic for service? Do they use these techniques or allow you in the garage to do all this?

wolverine

iTrader: (9)

if your lowered and no body kit a low profile jack would be enough. (it was for me) but lowered and with a body kit 2x4 is a must. so yea get that wood.