aznpapaya

iTrader: (12)

i'm looking for the size of our projector because i'm planning on getting some clear lense for it. i tried searching but came up with nothing so if anyone know please let me know, thanks.

Coconut

are you the originator of the papaya dome mod?!

aznpapaya

iTrader: (12)

that would be me

Tchan1

iTrader: (1)

I believe that the lenses are 3"

aznpapaya

iTrader: (12)

can someone confirm this? i dont wanna but it and then it wont fit.

DaSyce

iTrader: (3)

Based on HIDPLANET they are 3" and one of the worse projectors out there.. Clear lenses are not going to make a huge difference. Side mounted burners are the biggest flaw to our design.

Lexasaurus

iTrader: (12)

I remember reading somewhere that they are 3", i think it was a retrofit thread.

four o two

iTrader: (1)

They are 3". I wouldn't waste time modding the lense. The bowl/shield design is where you make your money. It's also where the design of the IS' projector goes broke.

ELL Y

iTrader: (1)

As others have stated, it's 3"
with some spacing, you could probably get a decent blue colorband. However, the width as well as smoothness of the output will still be pretty bad.

Tchan1

iTrader: (1)

Back then I purchase the GS350 projectors which is pretty much the same as the ISx50 projectors but has a 2.5" lenses instead. It was also sided entry for the bulbs.

Here is a picture of it on my first set of retro IS250 headlights. I swapped the OEM lenses with the s2000 clear lenses. No spacing modification, I just dropped it in. So there is only a little bit of blue and kind of a sharp cutoff.

aznpapaya

iTrader: (12)

thanks for everyone's comment and feedback, since i'm planning on taking my housing apart i was planning on doing some mod to it and friend of mine suggested that i change the lenses for better output and colors. from what i'm hearing from everyone i think i'll just wait and do a full retro fit.