DIY: LED console, steering wheel, and window controls
#16
Lexus Test Driver
#24
Pole Position
iTrader: (53)
what the led size for the ignition button??
Hey all thought I would share my little project I finished..I broke my ankle and had to have surgery so while I was home I decided to swap out my led's on my console, seat heater switch, steering wheel, door switches, and engine start button. Pretty much all the lights possible.
#27
Lexus Test Driver
iTrader: (1)
Join Date: Jun 2008
Location: NYC
Posts: 1,124
Likes: 0
Received 0 Likes
on
0 Posts
Looks like the OP was kidnapped and his life was threatened if he didn't take his DIY down.
Okay, well , there definitely WAS at least a partial DIY on how to remove the various panels, but now it's been replaced by this repost.
Okay, well , there definitely WAS at least a partial DIY on how to remove the various panels, but now it's been replaced by this repost.
#28
Lexus Champion
iTrader: (5)
Where did the DIY go?!
Well from what i remember, the LEds he used is size 1206 but plcc-2 is ok as well. The seatwarmer/cooler uses a 3mm bi color LED and there's a 5mm LEd somewhere.
There is also a 603 somewhere as well. I can't remember where.
Well from what i remember, the LEds he used is size 1206 but plcc-2 is ok as well. The seatwarmer/cooler uses a 3mm bi color LED and there's a 5mm LEd somewhere.
There is also a 603 somewhere as well. I can't remember where.
Last edited by 2slow; 03-11-09 at 01:55 PM.