aznboi27

Guys... and Gals...... to those who installed their own GFX front lip..... I took off all of the bolts (screws) on the bottom, but for the sake of God, I could not take the 2 clips on the ends off........... I tried pulling them with the screwdriver, but it seems like it's not budging, but just stripping the thing.....

Also, I've been doing searches on DIY front lips, and i noticed that a lot of you guys used tape. Mine didn't come with tape, so how much do I use and where do I apply it to once i figure out how to get those clips off? Thanks yo yo.

toomurf

spray some wd-40 and try to wiggle it out..... it's not that very hard

iialcii

iTrader: (3)

its should come off easy, its held on with double sided tape. heat it up, with a hairdryer or heat gun, it should come off easy.

myculito

iTrader: (1)

I'm sure your lip has tape. It's near the tips, and it's a really thin little strip on there. Check closely and you'll see it.

808Lexy

how can your gfx not come w/ the tape...i got mines from the dealer and it came w/ everything. the clips were real simple to pull out.

aznboi27

I don't know if we takling about the same thing. Are you guys talking about this?

USB_F

iTrader: (11)

All clips should come out pretty easily...at least they were for me.

808Lexy

all you need for that clip is a flat head screwdriver

aznboi27

sigh.. I tried.. I guess I'll go buy a smaller one. I tried a big screwdriver so I can have more leverage.

USB_F

iTrader: (11)

Work at it from all sides and wiggle it down at the same time.

Pnuge88

iTrader: (1)

for those clips you stick a flat head in then TWIST.. i hate those clips too. sometimes you'll get easy ones some of them just won't budge off at all.. but try that method and you'll get it out sooner then trying to pry it off by moving downward instead of twisting

Akatsuki

You have to do it slowly because it has like dust build up in there. Spray some wd40 and it should get moving. Take your time and pry it slowly tho

fasteddy91

iTrader: (5)

you need to get the center part out a just a bit, then pull on the outer clip to pull it out completely

DaSyce

iTrader: (3)

Or you can get a panel removal tool, and take it out without leaving a mark on it?

ecr527

You're better off using a smaller screw driver. A big one won't go into that little groove on the clip.