100degrees

iTrader: (1)

Just wondering if a 5mm spacer will clear the IS350 brakes? I see that both IS350 and ISF front wheels are 8"wide w 45 offset. So it should be very similar in fitment, no? Thanks in advance!

100degrees

iTrader: (1)

Anybody? =\ Also do ISF TPMS sensors work on the IS350 too?

100degrees

iTrader: (1)

Went ahead and did this today. All that's needed for the front are 5mm spacers. However the rears do look very sunken without any spacers as opposed to the fronts. I test fitted the rear with two of my 5mm spacers together and the car looks very proper so a 10mm rear spacer would fix the sunken look.

[IMG][/IMG]

robertrios

iTrader: (11)

Just got mine on yest, im hearing some rub but I have the OEM 225/40/19 fronts so when these wear out ill go down to the 35/19. How are you guys reshaping the plastics? Take the wheel off and use a heat gun? (could i use a blow dryer?) What is shaving? Sorry for the noob questions ive just never dealt with it before.
Thanks!

chikoo

ISF calipers are smaller than IS350?

birador

iTrader: (10)

are those 19's?looooook way soooo big for IS350

Jeff Lange

iTrader: (1)

No, they're just shaped differently, and sit further out from the center of the hub. Due to the shape of the spokes on the wheels, they hit the caliper closest to the hat of the rotor. It's because the IS350 brakes are smaller that the wheels hit, not because they are larger.

I had the same issue putting Venza 20" wheels onto a Camry which can fit 16", lol. Needed 3-5mm spacers to clear it.

It is also an issue with the JZA80 Supra brakes, even though it comes with 17" wheels, a lot of aftermarket 17's and even 18's or 19's hit the caliper due to how wide it is/its shape.

Jeff

DNAIS

iTrader: (11)

I did this as well with 11 ISF wheels on IS350. Heat gun, use brick or other hard object to push/shape fender liner away from wheels, spray cold water to set. Done.

SCWB

What is the spec of IS-F wheel?

BamaIS

iTrader: (3)

For using the heat gun...I left the wheels on and used a 1x4 that was about 2 feet long. Heated the plastic up and used the 1x4 against the tire for leverage to push the plastic in where it was rubbing. Held the board in place allowing the plastic to cool. Then the plastic held its new shape.

robertrios

iTrader: (11)

i gotta try this where do you guys buy heatguns?

BamaIS

iTrader: (3)

Home Depot, Lowes, Walmart

Vroomin350

iTrader: (28)

northern tools is selling a heat gun for $5.99 if you have one in your area.

100degrees

iTrader: (1)

Anyone run spacers on the rear for ISF rims? How big did you guys run?

FPLinek

I did it yesterday


IS350