Rear GFX lip installed without screw or cutting bumper
#1
Rookie
Thread Starter
Join Date: May 2007
Location: Miami FL
Posts: 94
Likes: 0
Received 0 Likes
on
0 Posts
Rear GFX lip installed without screw or cutting bumper
I decided to install the rear GFX lip but didn't want to cut my bumper nor put holes in it. The whole rear lip is held on by just the orignal 3m tape. Tell me what you guys think about the fitment since the opening around the exhaust wasn't cut. Debating on weather keeping this on or putting my F-style rear back on.
Trending Topics
#9
It looks good. Was there any part of the GFX rear lip that you could apply extra double sided tape? I'm not sure how much tape is originally in the rear lip so I can't reallys ay it will hold up but a decent about should keep it there unless you drive over a bump or side gutter where the lip could get caught, then you'll have a problem.
#12
Well, he lives in CA and rain occurs here a couple of times. There are those heavy downpours but it usually happens 1-2 times in a year, if it happens at all.
#15
Lexus Champion
iTrader: (3)
Join Date: Oct 2007
Location: FL
Posts: 3,003
Likes: 0
Received 0 Likes
on
0 Posts
Most of the time when double sided tape, 3M in general from my experience anyways it heats up from the sun/heat and then once it cools down it gets a better bond, especially when the surface is nice and clean AND the contact between the tape on the bumper and lip is perfect.