View Poll Results: Taillights
Voters: 86. You may not vote on this poll
Smoked vinyl taillights or Red-outs?
#32
Pole Position
iTrader: (1)
Join Date: May 2008
Location: GA
Posts: 291
Likes: 0
Received 0 Likes
on
0 Posts
Question for you guys who have done the install. How hard is it to get the vinyl to conform to the taillight where it sticks out a bit? I have a set from Aerotect and am installing them soon. I used to own a sign shop, so I have experience with vinyl. I just haven't installed anything of this thickness. Plus when you're doing full graphics on a car, a few mm off won't make a difference. But I'd rather get it perfect. I've read the instructions; I was just seeing if there were any tricks.
#33
It's not too hard at all, so I won't elaborate too much on it. I did mine & my wife's in the winter, so a hair dryer was pretty useful in keeping it malleable. Keep the sticky side and the light surface wet at all times, make sure you fill your spray bottle up pretty well, and good luck!
#36
Lexus Champion
iTrader: (10)
Join Date: Dec 2007
Location: Diamond Bar/Irvine, CA
Posts: 1,602
Likes: 0
Received 3 Likes
on
2 Posts
seems like most people get em either from aerotect or RVinyl
The whole discussion/debate between the two: https://www.clublexus.com/forums/sho...ghlight=rvinyl
The whole discussion/debate between the two: https://www.clublexus.com/forums/sho...ghlight=rvinyl
#41
Lexus Test Driver
I going to buy red outs from Rvinyl and plan to buy yellow fog overlays too... There are 2 types of yellow tho.
1. Saffron
2. Brimstone
What is the drffrence in these 2?
1. Saffron
2. Brimstone
What is the drffrence in these 2?
#42
Lexus Fanatic