HELP Car wont go into gear when on!
#1
HELP Car wont go into gear when on!
The Summary
new Clutch Installed. CC Stage 1
Everything seemed to be good
First car on will not go into any gear
After full slave cylinder bleed
Will go into 2nd 3rd and 4th
Poorly. Very choppy and grindy
Will not go into First Reverse or Fifth
What do i do next? I feel like clutch still not fully disengaging
When car is stopped and you start in any gear you feel the car jerk forward a little bit. Very slight
Is my clutch just not fully disengaging? What can i do next? As far as i can tell slave and mC are in good condition
fork travel is about the length of a finger, (sorry not very scientific) basically the rubber boot fully compressed to its natural resting state position maybe 1 inch? (slave cylinder boot)
Any ideas? I am dying here!
new Clutch Installed. CC Stage 1
Everything seemed to be good
First car on will not go into any gear
After full slave cylinder bleed
Will go into 2nd 3rd and 4th
Poorly. Very choppy and grindy
Will not go into First Reverse or Fifth
What do i do next? I feel like clutch still not fully disengaging
When car is stopped and you start in any gear you feel the car jerk forward a little bit. Very slight
Is my clutch just not fully disengaging? What can i do next? As far as i can tell slave and mC are in good condition
fork travel is about the length of a finger, (sorry not very scientific) basically the rubber boot fully compressed to its natural resting state position maybe 1 inch? (slave cylinder boot)
Any ideas? I am dying here!
Thread
Thread Starter
Forum
Replies
Last Post
baodalazi
SC- 1st Gen (1992-2000)
4
03-21-11 10:54 AM